Correct steps for daily cleaning of blow molding machines
Jan 27, 2025
To ensure the normal operation of the blow molding machine and extend its service life, daily cleaning is very important. The following are the correct steps for daily cleaning of the blow molding machine:
1. Power off and safety check
Before starting cleaning, make sure that the blow molding machine has been powered off and all circuit boards have been removed. This is to prevent any accidents and ensure the safety of the operator.
2. Clean the external surface
Wipe the external surface of the blow molding machine with a soft damp cloth to remove dust and stains. If there are stubborn stains, you can use a small amount of mild detergent to clean it. Be careful not to let the detergent penetrate into the machine.
3. Clean the moving parts
Use a fine brush, cotton swab or the small head of a vacuum cleaner to carefully clean the moving parts of the blow molding machine. These parts often accumulate dust, hair and other debris. Cleaning them can prevent the machine from clogging and ensure the blowing effect.
4. Clean the mold
If the blow molding machine has a removable mold, you can separate the mold, soak it in warm soapy water for a while, and then gently wipe it clean with a soft brush or cotton cloth. Be careful to avoid water entering the body part. Make sure the mold is completely dry before installing it back into the blow molding machine.
5. Clean the filter
Many blow molding machines have removable filters. Check the filter for dust and hair accumulation. If so, you can thoroughly clean the filter with water or a small brush. Make sure the filter is completely dry before installing it back into the blow molding machine.
6. Regular maintenance
In addition to daily cleaning, regular maintenance is also important. Check whether the power cord is damaged and pay attention to whether the operating sound of the blow molding machine is normal. If there is any abnormal sound or other problems, it is best to send the blow molding machine for repair or replacement.
7. Lubricate moving parts
After cleaning, apply an appropriate amount of lubricating oil to the moving parts of the blow molding machine to maintain a good state of friction and reduce wear.
8. Check the air and water sources
Ensure that the high-pressure air source, low-pressure air source, power supply and water source are normal. Check whether the emergency stop switch, safety door switch and protection device detection switch are normal.
Through the above steps, you can effectively keep the bottle blowing machine clean and running normally, extend its service life and provide a better bottle blowing experience. Remember to follow the correct cleaning steps and safety precautions to keep the bottle blowing machine clean and safe at all times.
